Advertisement
Available languages
Available languages
Using the handle
You can use the handle to carry
the tablet PC conveniently with
one hand from below and operate
it with the other hand.
The handle is attached to the
holder with the velcro pad at any
angle.
After positioning, press the
handle completely to the velcro
pad of the holder.
Check the velcro connection
before you use the tablet PC with
the handle.
NOTICE
Velcro connection can wear out or get dirty
If you change the handle position frequently, the velcro connection can wear out or get dirty. The adhesive force is reduced
in this case and the tablet PC may drop.
Note the following each time you reposition the handle:
Check the contact areas of the velcro connection and remove any dirt that may have accumulated.
•
After positioning, press the handle completely to the velcro pad of the holder.
•
If the adhesive force of the velcro connection is no longer sufficient, replace the holder and the handle.
•
Using the carrying strap with the support
With the carrying strap you can
operate the tablet PC
conveniently and the device is
protected from being dropped.
The figure on the right shows two
carrying straps, one neck strap
and one waist strap.
Fasten the carrying strap with the
snap hooks to the corresponding
eyelets of the support.
Using the carrying strap without support
To use the carrying strap without
the support, install the two
provided eyelets according to the
figure at the top on the rear of the
tablet PC.
For mounting, replace the two screws at the marked positions with the two screws and washers from the scope of delivery.
Fasten the screws. Hand-tighten the screws.
Check regularly whether the screws are still tightened sufficiently and retighten them, if necessary.
Support with handle and carrying strap
A5E46835788-AA, 03/2019
4
Siemens AG
Division Digital Factory
Postfach 48 48
90026 NÜRNBERG
Support with handle and carrying strap
GERMANY
A5E46835788-AA, 03/2019
Advertisement
