Initiation; Scope Of Application; Installation; Operation - Intimus 175 SP2 Operating Manual

GB
2

Initiation

2 .1 Scope of application

CAUTION!
Damage to the cutting mechanism!
The machine must only be used to shred
paper!
Shredding of other types of data carriers
and also of staples and paper clips with the
models with cutting width 0.8x12 mm (CP6/
CC5) or 0.8x4.5 mm (CP7/CC6) may lead to
injuries (for example due to splintering of
hard materials etc.) and damage to the ma-
chine (for example destruction of the cutter
etc.).
Exception: Single CD's or 3.5" computer dis-
kettes can also be shredded with 3 .8mm,
5 .8mm, 4x40mm, 1 .9x15mm models.
The document shredder intimus 175SP2(SC2)/
CP4(CC3)/CP5(CC4)/CP6(CC5)/CP7(CC6) is a machi-
ne for the destruction of common written material.

2 .2 Installation

1 . Unpack and set machine upright.
2 . Place plastic sack into the receptacle.
3 . Machines with automatic oil system: For oiler in-
stallation remove the screw (fig. 1/2) from the oil
hose (fig. 1/1).
1
Oil hose
2 Screw
fig. 1 Oiler installation
4 . Connect the machine to the power with the plug.
(For information on the right fuse for the plug see
„Technical Data", p. 18).
12
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
3

Operation

3 .1 Controls

9
8
7
6
1
Functions button
2
Forwards button
3
Control display „Motor overload" / „Electrical fault"
4
Control display „Collection bin full"
5
Reverse button „Stop" / „Reverse"
6
Control display „Door open" / „Door malfunction"
7
Control display „Oil cutters" / „To change the oil con-
tainer"
8
Control display „Material jam"
9
Control display „Load level of the motor"
fig. 2 Controls „i-control"
= Functions button (fig . 2/1)
1
a) „Ready"
The machine changes to "Ready" if you press this
button briefly. At the same time the integral LED
display
b) „Off"
The machine switches off if it is in the "Ready"
1
mode and the button is held down for about
3 seconds.
NOTE!
The machine switches off automatically if it is
2
not used for about 15 minutes.
c) „Stop"
000174
If you press this button briefly when the cutters
are running they switch off and stop.
= Forwards button (fig . 2/2)
2
If this button is pressed, the cutting mechanism
runs forwards for a few seconds, e.g. to remove re-
maining material from the cutting mechanism. At
the same time the integrated LED display
up.
By pressing and holding this button when the mo-
tor has stopped, the cutting mechanism runs for-
wards.
1
comes on.
2
3
4
5
000152
lights
91239 7 08/20