Replace The Batteries - Kohler K-10956 Maintenance Manual

Batteries

Replace the Batteries

NOTICE: Do not over tighten the screws. The plastic threads on the
screws can be easily damaged.
NOTE: When purchasing replacement batteries, select four 1.5 volt
AA alkaline batteries.
NOTE: If replacing the sensor, install a battery in the new sensor
unit before installing the sensor.
NOTE: It is not necessary to remove the sensor from the cap to
replace the batteries.
Using a 3/32" hex wrench, remove the two screws from the
bottom of the DC sensor.
Remove the battery holder from the DC sensor.
Using small flat-blade screwdriver (if necessary), carefully pry the
batteries from the battery holder.
NOTE: The batteries may be considered hazardous waste. Discard
the old batteries in accordance with any applicable codes.
Remove and discard the old batteries.
NOTE: Note the polarity stamped on the battery holder for proper
battery placement.
Insert the new batteries into the battery holder.
Reinstall the battery holder into the DC sensor.
Kohler Co.
DC Sensor
Battery Holder
Screws
9 1058866-5-D