Table of Contents
Advertisement
WX-5520A Dual Band Access Point
Resolution:
§ Make sure that each computer has a unique IP Address. If using DHCP through the AP ,
makes sure that each computer is set to "Obtain an IP Address automatically" and
restart the computer.
§ Make sure that the Link LED is on. If it is not, try a different network cable.
§ Check each computer for correct network settings.
Wireless Troubleshooting
I can't access the Wireless AP from a wireless network card
Cause:
§ Out of range.
§ IP Address is not set correctly.
Resolution:
§ Make sure that the Mode, SSID, Channel and encryption settings are set the same on
each wireless adapter.
§ Make sure that your computer is within range and free from any strong electrical
devices that may cause interference.
§ Check your IP Address to make sure that it is compatible with the Wireless AP.
Performing a Factory Reset
Follow these steps to perform a Factory Reset using the Reset button on the back of the
Wireless AP.
1.
With the unit on, press and hold the Reset button with a pen or paper clip.
2.
Hold the reset button for about 5 or 6 seconds until the Status LED on the front
panel blinks very quickly and then release.
3.
Wait a few seconds for the AP to reboot using default settings.
A Factory Reset can also be performed through the web configuration interface. Follow
these steps to perform a factory reset using the web configuration interface.
1.
Log-in to the Wireless AP web configuration interface.
2.
Click on Restore Default.
3.
You will be asked if you want to restore to default settings. Click OK to restore
settings to default configuration or click Cancel to discard any changes.
Wireless Broadband Anywhere
16
Advertisement
Table of Contents
