Subscribe to Our Youtube Channel
Related Manuals for Gemtek WLTMS-110-HGA
Summary of Contents for Gemtek WLTMS-110-HGA
- Page 1 LTE Cat6 TD-LTE CPE Quick installation Guide WLTMS-110-HGA / WLTMS-110 LTE Outdoor CPE Connection Guide...
-
Page 2: Table Of Contents
Contents CONTENTS……………………………………………….….1 1. CONNECTORS ..........2 2. LED INDICATORS .......... 3 3. INSTALLING LTE OUTDOOR CPE ....4 4. CONNECTING THE CABLES ......5 5. WEB INTERFACE ........... 7... -
Page 3: Connectors
Connectors 1. One RJ-45 connector for connecting to the PoE adaptor. 2. LED indicator inside and SIM card slot for inserting SIM card. 3. A grounding screw on the rear panel. -
Page 4: Led Indicators
LED Indicators LED Name Location Color LED Behavior Status Indication LED list Power On Main Power Blue Power Off Detect Ethernet Steady ON Device Connected Ethernet Yellow Blinking Status No Ethernet action Steady ON SIM Detected Blinking when SIM status Green PUK / PIN Code On-hook... -
Page 5: Installing Lte Outdoor Cpe
Installing LTE outdoor CPE Selecting a Location: LTE Outdoor CPE should be pole-mounted outdoors and aligned so its antenna faces the nearest LTE eNB. When selecting a suitable location for the unit, consider these guidelines: Place LTE Outdoor CPE as high as possible to achieve the best •... -
Page 6: Connecting The Cables
Connecting the Cables Outdoor Connection: Connect a grounding cable between the Ground terminal of the LTE outdoor CPE and a good ground connection. Preparing and connecting the cable: Use only 5E 4x2x24# FTP (or from an approved manufacturer. above) outdoor Shielded Patch Cable 1. - Page 7 • Insert the cable into the sealing gland base and connect it to the RJ-45 connector at the bottom of the CPE. Make sure the connector is completely inserted and tightened. • Insert the rubber bushing on the cable into the gland base. •...
-
Page 8: Web Interface
Web Interface Please follow the steps below to configure your device through the web interface: Open the Web browser (Internet Explorer) and enter the default IP Step1: address of the ODU CPE, which is : http://192.168.15.1 Enter ODU guest login username/password to access the web Step2: management interface. - Page 9 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 10 RF exposure requirement. 3. External antenna Use only the antennas which have been approved by Gemtek, BLiNQ. The non-approved antenna(s) may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC limit and is prohibited.
Need help?
Do you have a question about the WLTMS-110-HGA and is the answer not in the manual?
Questions and answers