Threading The Machine; Winding The Bobbin - Brother XL-2610i Operation Manual

KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

THREADING THE MACHINE

Winding the Bobbin

CAUTION
●
Only use bobbins (part code: SA156, SFB (XA5539-151)) that have been designed for this
sewing machine. Using other bobbins may cause damage to the machine.
●
We designed the bobbin that comes with this machine. If you use bobbins from other models,
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB (XA5539-151)).
1
1 Put the spool of thread on the spool pin and
pass the thread around the pre-tension disk.
CAUTION
●
If the spool of thread is not in the right
place, the thread may tangle on the spool
pin.
16
Actual size
11.5 mm
(7/16 inch)
This model
1Pre-tension disk
2Bobbin winder shaft
Other models
2 Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
2