Vulcan-Hart C24EO Series Service Manual page 12

Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
Assembly
1. Apply Lubriplate 630AA to sides of sliding
bracket.
2. Insert spring pin into bottom of sliding bracket.
A. Place spring over spring pin.
3. Assemble sliding bracket into stationary bracket.
4. While holding head of spring pin against bottom
of sliding bracket, insert spring pin into keeper
hole in bottom of stationary bracket.
A. Secure spring pin in place with retaining pin.
NOTE: Install pins such that heads of pins will be
facing inward toward hinge side of inner door panel
when latch assembly is installed.
5. Install pins to assemble stationary and sliding
brackets together.
A. Secure pins into position with E-clip.
Installation
1. Install latch assembly onto inner door panel with
spring pin toward bottom of door panel.
A. Apply Loctite 271 to threads of screws
before assembly and secure latch assembly
to inner door panel.
2. Install outer door housing assembly as outlined
in DOOR HANDLE INSTALLATION.
F25386 (June 2010)
2940 Hwy 14 W, Rochester, MN 55901
3. Check opening and closing operation of door.
4. Check steamer for proper operation and leaks
Hinge Bearings
1. Close door.
2. Remove left SIDE PANEL.
3. Remove nuts from upper hinge located inside
4. Open door slightly, and while holding door, pull
5. Pull upper hinge out of upper door hinge bearing.
6. Lift door assembly up and off lower door hinge.
7. Pry hinge bearing out from door assembly.
8. Remove outer door housing.
door panel could be damaged. Press bearing into
position.
NOTE: When replacing door hinge bearings, replace
both hinge bearings.
9. Position replacement hinge bearing over hinge
10. Reassemble parts removed in reverse order.
11. Check door for fit and proper door gasket
Page 12 of 24
around door seal.
front panel.
upper hinge away from front panel.
Do not drive bearing into place. The inner
opening in door assembly.
A. Press hinge bearing fully into door assembly
using a C-clamp or equivalent.
sealing.