Casio CTK-900 Midi Implementation Manual page 45

Data Management Command List
ParamID Parameter
20w Prepare for Data
Management
(Note 1)
21r Free Size of Song
(Note 2)
22r Free Size of SMF/
Wave/Rhythm
(Note 3)
23w Delete Song
24w Delete Rhythm
25w Delete Tone/Wave
26w Delete Drum/Wave
27w Delete SMF
28w Store
29w Initialize
2Aw Console Command
Note 1:
Receipt of this parameter causes this Model to terminate all music and note play, and enter a mode that is optimized for
bulk dump.
Note 2:
This parameter stores a value, in bytes, that indicates the remaining free Song area memory.
Note 3:
This parameter stores a value, in bytes, that indicates the remaining free SMF/Wave/Rhythm area memory.
Note 4:
The 32-bit value of this message indicates the part number (Tone and Drawbar parameter set categories only), parameter
set category, and the parameter set being written to, as shown in the table below.
Bit Field
24-31 Part (Tone, Drawbar)
16-23 Parameter Set Category
0-15 Destination Parameter Set Number
See "39 About Parameter Set (PS) Numbers" for details about user parameter set numbers.
Note 5:
The initialization target is all parameters that can be modified by the Mixer edit mode.
Note 6:
The initialization target is the temporary area being influenced by operation of the current device, but does not include
previously stored user parameter sets or song data. This means that all Mixer parameters are included. The LCD contrast
setting is not affected.
Note 7:
The initialization target is the entire Flash memory, which is returned to its initial factory default state.
ps index bit
0 00 07
0 00 20 0-FFFFFFFF
0 00 20 0-FFFFFFFF
0 0 10 0-FFFF
0 0 10 0-FFFF
0 0 10 0-FFFF
0 0 10 0-FFFF
0 0 14 0-FFFF
0 0 32 0-FFFFFFFF
0 00 07
0 0 10 0-FFFF
Content
45
Value Default Setting Value (Decimal)
0-127 0
0
0
0
0
0
0
0
-
00-7F -
-
0...Prepare
Free size (bytes)
Free size (bytes)
Song Number
Rhythm Number
Tone Number
Drum Number
SMF Number
Part/Category/Number
(Note 4)
0...Mixer(Note 5)
1...Parameters(Note 6)
2...System(Note 7)
0000...Update DSP LED