Operators Obligations; Safety Instructions For Maintenance-, Inspection- And Assembly Works - BEKA -MAX Original Operating And Assembly Manual

3.3 Hazards in case of non-observing the safety instructions
Results of non-observing
central lubrication pump itself. The non-observance of the safety automatically leads to the loss of any libility.
In detail the non-observance could entail the following hazards:
· Failure of important function of the central lubrication pump.
· Failure of prescribed methods for maintenance and repair.
· Danger to persons by electrical, mechanical and chemical effects.
· Danger to the environment by leakage of hazardous substances.
3.4 Operators´obligations
· If movable, rotating, hot or could parts of the device bear risks, these need to be secured against contact
by the customer. This protection against contact must not be removed.
· Any leakages of hazardous substances to be conveyed must be drained in a way that no risk for persons
or the environment arises.
· Statutory provisions are to be observed.
· Hazards due to electricity are to be excluded.
· Examination of pipes and hoses regarding safe provision, use, proper assembly and function has to be
carried out according to regionally applicable directives. Inspection periods may not be exceeded.
· Defective pipes or houses must be replaced immediately and appropriately.
· Hydraulic hoses and polyamide pipes are subject to a natural aging-process and thus have to be
exchanged in regular intervals according to the manufacturer´s specifications.
· Asafety data sheet of the currently used lubricant needs to be provided at the device.
3.5 Safety instructions for maintenance, inspection and assembly
All maintenance, inspection
sufficiently informed by thorough reading of the user information.
Generally all works
as well as disconnected condition
among others) is necessary. The shutdown procedure of the central lubrication pump as described in the
manual must be strictly followed.
Secure the central lubrication pump against intentional or unintentional restarting during maintenance works
or repair. All safety and protection arrangements have to be put back in place again immediately after
finishing the works.
Media that endangers the environment must be disposed in accordance with pertinent official specifications.
Polluted and contaminated surfaces
protection equipment to that purpose. See the lubricant manufactures´safety data sheets hereto,
respectively the data sheet provided by the manufacturers of auxiliaries and working materials.
...a product of BEKA
the safety instructions
and assembly works
at the device may only be carried out during
. Furthermore appropriate
have to be cleaned before maintenance works. Please wear
5
can be hazard for persons
may only be carried out by trained expert staff
complete standstil
personal protection equipment
, environment and for the
who is
l and in pressureless
(goggles
© BEKA 201 All rights reserved 5 !