Page 2
F-B200GL NB-IoT module hardware design manual Files Revised Record Date Version Remark Author 2019/7/2 V1.0.3 Initial version Jim Chen 2 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Page 3
All contents in the files are protected by copyright law, and all copyrights are reserved by Xiamen Four-Faith Communication Technology Co., Ltd. Without written permission all commercial use of the files from Four-Faith are forbidden, such as copy, distribute, reproduce the files, etc., but non-commercial purpose, download or printed by individual (all files shall be not revised, and the copyright and other proprietorship notice shall be reserved) are welcome.
Cat.NB1: Maximum uplink rate is 70kbps Maximum downlink rate is 32kbps Support Network Protocol PPP/TCP/UDP/COAP/MQTT/LWM2M/SSL/TLS/FTP(S)/HTTP(S). Support PAP (Password Authentication Protocol) and 7 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Used for software download, Module debug and log output The commands defined by 3GPP TS 27.007 and 3GPP TS 27.005, AT Command and add the new commands from Xiamen Four-Faith Technology Include the main antenna interface (ANT_MAIN) and the BT Antenna Interface...
3. Due to diode drop of chipset inside, The PWRKEY pin will output 1.0V 2.2 I/O Definition Form 2-1 I/O Definition 10 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
VDD_EXT power domain, GPIO_36 input/output unused state: float. General purpose VDD_EXT power domain, GPIO_34 input/output unused state: float. 11 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Page 12
Data receive unused state: float. UART4 interface Pad # Pad Name Description Remark HST_RXD Data receive VDD_EXT power domain, 12 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Page 13
Need connect with VBAT Only external GPS RTC LDO Output for V_BAT_RTC power supply, no load VBAT_RTC capacity ADC interface 13 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
F-B200GL can make power consumption through the e-I-DRX mode. The power consumption of e-I-DRX slightly higher than PSM. But compared with PSM, the 14 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
AT+CPSMS=1 or AT+CPSMS=1 command to enable PSM. When the module in PSM state, you can awaken the module under the following 15 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
The reference design of the power supply circuit is as follows: Figure 2-2 Power Supply Reference Design 16 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Another way to control PWRKEY pin is through a button switch directly. A TVS is placed near the button for ESD protection. Figure 2-4 Button Startup Reference Circuit 17 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
If you do not need the USIM_PRESENCE pin to detect (U)SIM card, please keep it float. The reference circuit as follows: 19 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Page 20
(U)SIM card connector. 7. The pull-up resistor of USIM_DATA can increase the antijamming capability of 20 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
Form 2-14 STATUS Pin Description Pad # Pad Name Description Remark STATUS Working status indication 1.8V power domain Reference Design: 23 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
In order to the regulation of RF performance better, it is recommended to reserve the π-type marching circuit. The π-type matched components (R1/C1/C2) should be 24 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
3GPP standard. It means that when the module working in this temperature range, the module 29 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
3. If the module is in the following conditions, it needs to be baked before the SMD: 32 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
PCB board completes the reflow welding. The recommended furnace temperature curves are shown as follows: Figure 7-1 Reflow Temperature Curve 33 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...
194.21mm long and 184.18mm width, include 49 F-B200GL modules. The pallet size is shown as follows: Figure 7-2 Pallet Size 34 / 34 Add: Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen. China http://en.four-faith.com Tel: +86 592-5907276 Fax: +86 592-5912735...