Advertisement
tardants in the event of a misfire.
Avoid touching the exhaust system and other parts that become hot when using, in order to
prevent burns. Pay attention to the warning notices on the product.
Do not modify the device structurally and do not operate it at too high a speed, as this affects
the longevity of the product and means an increased risk of injury.
Check the fuel system of the device regularly for leaks and signs of wear, e. g. porous areas
on hoses, damage to the tank or missing clamps. Also, make sure that all parts are in good
condition before using the device.
Always make sure that your workplace is adequately lit.
Do not pick up the machine with the engine running; only move it to another location when it is
turned off and cooled down.
Always switch off the engine when not in use and before refuelling, cleaning, maintenance and
repair work and let the device cool down first.
Before checking or adjusting the machine, pull the spark plug or ignition wire to prevent acci-
dental start-up.
Do not use the device when you are tired, under the influence of alcohol, drugs or medication.
Observe the locally applicable regulations. These could limit the use or the duration of use of
the multifunction device.
When working with the device, always wear face and ear protection as well as non-slip safety
shoes with steel caps and cut protection gloves. Never operate the device barefoot or with
open, loose or otherwise unsuitable shoes.
When working with the device, always ensure that you have a firm and secure footing.
The device is designed for two-handed operation. Hold the handle firmly with both hands and
never work with just one hand. Always use the shoulder strap when working and never let go
of the device while the engine is running.
Always use the blades and bobbins recommended by the manufacturer.
Regularly inspect the device and check it for damage if it has been dropped or subjected to
impacts.
Stand up straight and take regular breaks so that you no longer put too much strain on your -
self.
Safety of maintaining, cleaning and transporting
Store the device in a dry place and out of the reach of children. Also protect it from rain and
moisture when in use.
Never store the device filled with petrol in surroundings in which escaping vapours could be ig-
nited by sparks or open sources of ignition.
Before storing, wait until the device has cooled down completely.
To reduce the risk of fire, keep the storage area free of easily inflammable materials.
Replace worn or damaged parts, and do not attempt to repair them.
Never use the device without the corresponding protective plates.
If the fuel tank needs to be emptied, do so only outdoors; escaping vapours mean both a fire
and a health hazard.
Clean and maintain the device before storing it. Also make sure that all nuts and bolts are
properly tightened.
Store the blades of the device in a dry place to avoid rust formation; do not use rusty or un -
sharp blades as this will reduce performance and increase the risk of injury.
To be able to transport the device, please note the following:
1. Switch the device off and let it cool down.
2. Remove the spark plug to prevent the device from starting accidentally.
3. Wear cut protection gloves to remove the blade.
4. Only carry the device by the handles. Place it in the vehicle so that it cannot tip over and
the blades cannot injure anyone. With the device tipping over, fuel could leak or people
near the device could be injured.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61494
Page 6
03
2021-1
Advertisement
