Summary of Contents for Reichert Longlife Project-O-Chart
Page 1
12084 Longlife™ Project-O-Chart® Parts and Service Manual...
Page 2
Reichert shall have sole control of the defence company should be requested to make out a “Bad of any such action with information and assistance Order”...
Instruction Manual 12084-101 which is packaged with the instrument or can be ordered through Reichert Ophthalmic Instruments 3374 Walden Ave. Depew, New York, 14043. 12084-102 Rev B Page 4...
1. TROUBLESHOOTING CHART POSSIBLE CAUSE SYMPTOM 1. P-O-C not positioned correctly - see Correct size image cannot be obtained instructions for proper positioning 1. Lenses in projection tube improperly Image cannot be focused installed 2. May require auxiliary lens to be installed 3.
2.3 PROJECTION TUBE DISASSEMBLY AND 2. DISASSEMBLY, REASSEMBLY AND REASSEMBLY - Refer to Figure 2. ADJUSTMENT It is not normally necessary to disassemble the 2.1 REAR COVER REMOVAL AND projection tube. After prolonged use (several REPLACEMENT - Refer to Figure 3. years), depending on the environment, a film may form on the inside surfaces of the lenses.
2.5 ELECTRICAL ASSEMBLY REMOVAL AND 2.8 CROSS SLIDE DETENT ADJUSTMENT - REPLACEMENT - Refer to Figure 3. Refer to Figure 3. 2.5.1 Remove the rear cover. 2.8.1 Remove the rear cover. 2.5.2 Remove the screws (87) securing the 2.8.2 Loosen the screw (54) and adjust pin (50) bracket and remove the bracket.
4.1 HIGH LINE VOLTAGES (120-130 OR 240-260 SETTlNG LINE VOLTAGE SELECTOR VOLTS) The line voltage can be set for either 115 volt If the local line voltage is at least 10 volts nominal operation or 230 volt nominal greater than the nominal voltages mentioned operation.
Parts should be ordered directly from an authorized Reichert Ophthalmic Instruments distributor. When ordering parts, be sure to include a complete description, part number and correct quantity. 12084-102 Rev B Page...
Need help?
Do you have a question about the Longlife Project-O-Chart and is the answer not in the manual?
Questions and answers