Table of Contents
Advertisement
Installation
It is recommended that prior to starting the installation, you read this installation sec-
tion completely and follow the instructions. In addition, consult the manual of the audio
device to which you will be connecting the SCH1 Tuner to determine the required
installation configuration.
The SCH1 Tuner can be connected to a SIRIUS-Ready receiver using the DIN cable,
or by using the provided RS-232 Adapter Cable.
When connecting using a DIN cable:
•
If power for the SCH1 Tuner is not provided by your audio device via the DIN cable
connection, you will need to use the provided AC Power Adapter to provide power
for the SCH1 Tuner.
•
If audio input from the SCH1 Tuner is not supported via the DIN cable connection
of your audio device, you will need to connect the audio output of the SCH1 Tuner
to your audio system via the RCA-type or Optical audio output connectors of the
tuner. (You will need to purchase the appropriate cable separately.)
When connecting using the RS-232 Adapter Cable:
•
The AC Power Adapter must be connected to the power connector on the RS-232
Adapter Cable.
•
note: do not connect the aC Power adapter to the SCH1 Tuner when us-
ing the RS-232 adapter Cable
The maximum length of RG-6 cable between the Outdoor Antenna and the SCH1
Tuner is 50 ft. For longer lengths the Splitter/Amplifier must be used. When the Split-
ter/Amplifier is used, the maximum lengths of RG-6 cable are 100 ft. from the Outdoor
Antenna to the Splitter/Amplifier, and 50 ft. from the Splitter/Amplifier to the SCH1
Tuner. (Refer to Figures 15 & 16.) RG-6 cable(s) are not provided.
[
]
11
Installation
Advertisement
Table of Contents
