Warning Messages For Damage To Property; Warning: Power Supply Safety; Caution: Wireless Safety - ABB Ability User Manual

A B B A B I L I T Y E D G E I N D U S T R I A L G AT E W AY
T M
To indicate a potentially hazardous situation which, if not avoided, could result in minor or
moderate injury, the following message is used:
CAUTION!
Sign (if necessary)
TEXT THAT EXPLAINS THE HAZARD AND THE CONSEQUENCES OF NOT AVOIDING IT
Text that explains how to avoid this hazard

1.4.2 Warning messages for damage to property

To indicate potential risks of damage to the supported product (or to other property), the
following message is used:
NOTICE
Sign (if necessary)
Text that explains how to avoid damaging the supported product (or other property)
—

1.5 Warning: power supply safety

WARNING!
ELECTRIC SHOCK HAZARD
Failure to supply power correctly or to follow all operating instructions correctly, may
create an electric shock hazard, which could result in personal injury or loss of life, and /
or damage the equipment or other property.
To avoid injuries and safely supply power to the product, complete the following steps:
1. Observe all the instructions for safety, installation, and operation.
2. Make sure your hands are dry.
3. Make sure that all the cables used:
• Are in good condition before using them.
• Meet the product requirements and comply with the relevant standards and
regulations.
4. Position cables with care. Do not position cables in places where they may be
trampled or compressed by objects placed on them.
5. Make sure that the power-points and plugs are in good condition before using them
6. Do not overload the power-points and plugs.
7. Make sure that the product maintains a proper grounding connection.
8. Use a power supply that meets the product requirements and complies with the
relevant standards and regulations.
9. Connect power after the installation of the system has been completed.
10. Never connect or disconnect the cables with the system or the external apparatus
switched ON.
—

1.6 Caution: wireless safety

The antennas used in the product have to be installed with care, to avoid any interference
with other electronic devices and to guarantee a minimum distance from the body (20 cm).
In case of this requirement cannot be satisfied, the system integrator has to assess the final
product against the SAR regulation.
11