Advertisement
Available languages
Available languages
Configuration
You can associate your receiver with several
transmitters and conversely several receivers
with a transmitter, each with a different tune:
• 1 different tune per receiver.
• 1 different tune for each activated transmitter.
• 1 different tune per receiver according to the
activated transmitter.
Selection of a tune
A tune may be selected by a short pressure
(< 3 seconds) on tunes selection button
the receiver. The last tune played will be used
during association.
An 11
th
option is available (except for 53620):
the indicator light goes on without tune.
After association, new "Configuration" is
!
required to modify the tune.
Association of a receiver with a transmitter
Once the tune is selected, briefly press
configuration button
of the receiver.
A "beep" will signal that the receiver is in
"Configuration" mode.
< 3 sec.
Press configuration button
of the transmitter.
The receiver plays the tune selected and returns
to the normal mode.
M r DU PO NT
!
When configuration button
is pressed and 2 minutes pass whithout
pressing configuration button
transmitter, the receiver returns to the
normal mode.
Repeat the operation to associate several
transmitters and receivers.
Reset
PARTIAL (removing a link between a receiver
and a transmitter)
,
Press configuration button
two "beeps" are heard.
Press configuration button
of the transmitter
you want to dissociate. Several "beeps" are
transmitted by the receiver. The receiver has
cleared the link with the transmitter.
M r DU PO NT
Hager S.A.S. - 132 bd d'Europe - B.P. 78 - 67212 Obernai cedex (FRANCE) - Tél. +333 88 49 50 50 - www.hagergroup.net
TOTAL (removing all links set up with the receiver)
Press configuration button
two "beeps" are heard.
of
Press again configuration button
until several "beeps" are produced. The receiver has
removed all its links.
BIP
Volume adjustment
Volume can be adjusted by setting selector
receiver in one of the four positions: "high", "medium",
"low" and "silence".
"Baby sleeps" feature: extended pressure
(> 3 seconds) on tunes selection button
it possible to set the chime in noise reduction mode
(45 dB) for 3 hours.
A short pressure on tunes selection button
stop the noise reduction mode and return to the normal
mode.
Installation options
In order to protect your transmitter from theft or
of the receiver
damage, it can be installed in a safe place (water-
proof nonmetal box, i.e. IP55).
of
Fitting a remote push-button (terminals 0 and 1)
of receiver until
BIP
BIP
Extension of an existing wire installation with
connection to a safety transformer (terminals 0
and 2)
BIP
BIP
BIP
...
of the receiver until
of the receiver
allows to
0 1
Mr DU PO NT
1
0
Mr DU PO NT
_ _ _
____
8-12 V
Troubleshooting
• Push-button LED flickers:
- the battery is dead, change it.
• The application does not start:
- The receiver or the transmitter is not power
supplied, check the batteries, the circuit
BIP
breaker or the power supply.
BIP
- The receiver or the transmitter is in an
area subject to interference (amateur radio,
television, GSM terminal network, etc.): move
the receiver or the transmitter out of the
interference area.
- The receiver is out of the transmitter range,
move it closer.
-
The
receiver
the transmitter, reinstall the receiver and re-
configure.
• You must replace a transmitter:
- Do a reset of the receivers and reconfigure.
If the problem remains, contact your electrician.
BIP
Technical characteristics
BIP
Transmitter
Supply voltage:
BIP
Battery ref.:
...
Lifetime:
2 years or 7000 operations
IP:
Insulation class:
Receiver category:
Typical range:
Operating T°:
Storage T°:
Hygrometry:
Section of wires:
Dimensions:
of the
Receivers
Supply voltage:
or mains adapter ref. 53699
Battery ref.:
Lifetime:
2 years (10 tunes played/day)
makes
Frequency:
IP:
Insulation class:
Transmitter duty cycle:
Operating T°:
Storage T°:
Hygrometry:
Dimensions:
Volume levels:
60 dB low, 70 dB medium,
Hereby, Hager Controls, declares that this chime
receiver is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC.
The CE declaration can be consulted on the
site http://www.hagergroup.net
Usable in all Europe
How to eliminate this product
(electric an electronic waste) ?
(Applicable in the European
Community and other European
countries implementing waste
collection programs).
This symbol on the product or its documentation
indicates that the product shall be collected
separately from other domestic waste.
Uncontrolled waste disposal may result in damage
to the environment and risk for human health.
Contribute to sustainable use and recycling of
material resources.
Private individuals are invited to contact the
distributor of these products or public authorities
to find out what are the local regulations in force
for sustainable waste collection and disposal.
Companies are invited to contact their suppliers
and review sale contract Terms & Conditions.
This product shall be collected and eliminated
separately from other commercial waste.
does
not
recognize
1 battery 3V
CR2032
55 (if cabled, IP40)
II
2
200 meters in open field
-20 °C at +50 °C
-20 °C at +70 °C
90% at 20 °C
0.5 mm
2
max.
76 x 49 x 23 mm
3 batteries 1.5V
LR14/type C
433.92 MHz
20
II
10%
0 °C at +45 °C
-20 °C at +70 °C
90% at 20 °C
153 x 99 x 41 mm
85 dB high
6T 7725-00c
Advertisement
