Advertisement
2 Quick start
The following steps are required to install and start using the Atmel ATAVRBM300:
1. Install Atmel AVR Battery Studio 2.
2. Connect ATAVRBM300 to ATBMxxx-EK.
3. Connect ATAVRBM300 to a USB port of the PC.
4. Start AVR Battery Studio 2.
The install file of AVR Battery Studio 2 can be downloaded from the Atmel website:
www.atmel.com/BM300. The 10-pin communication port of ATAVRBM300 should be
connected to the communication port of ATBMxxx-EK as shown in
Figure
2-1.
Figure 2-1. ATAVRBM300 connect to ATBMxxx-EK.
About AVR Battery Studio 2 introduction please refer to application note Atmel
AVR363 AVR Battery Studio 2 user guide.
Atmel AVR390
2
8463A-AVR-11/11
Advertisement
