Table of Contents
Advertisement
SPEED AND DISTANCE INDICATOR MODE CHANGE
Change of information displayed on the display
can be done by short press of the button
TRIP
Lenght
of the trip
DISPLAY BACKLIGHT CONTROL
To turn the display backlight on or off, hold
A
the
button for 2 seconds. During bad light
conditions, the backlight turns on automatically.
If it then turns off, it's necessary to turn it on
manually. The intensity of the backlight can be
set – see Parameters setting further. Doing this
will also turn on and off the front/rear lights on
Tour models.
ERASING TEMPORARY DATA
To erase temporary data, proceed according
to article Parameters setting. You will get to
erasing of temporary data through "Display
setting" and "TRIP reset" (as soon as the line
TRIP reset is highlighted, press the
and set the "YES" value via
Then confirm it by the button
data will be erased). Temporary data will be
automatically erased after reaching 99:59 h of
total ride time. Temporary data won't be erased
in case of turning the display off.
PARAMETERS SETTING
To enter the parameters setting mode press the
G
button twice with interval ca. 0,3 seconds.
To switch between different menu items and
the parameters setting change use buttons
A
C
and
. To confirm your choice, press the
G
button. To end the parameters setting mode,
G
press the
button twice with interval ca. 0,3
seconds. In case of inactivity for 10 seconds the
parameters setting mode ends automatically.
8
H
ODO
MAX
Total
Maximum
distance
speed
G
button
A
C
and
buttons.
G
and temporary
.
AVG
Average
Speed
ITEM DISPLAY SETTING
Unit – unit setting (km/mile)
Brightness –display backlight intensity setting (10, 30,
50, 75 or 100 %)
Auto Off –setting of automatic display shutdown
(1–9 min)
Max Pas – setting of assistance number (3/5/9)
Power View – setting of power indicator format
(power/torque)
SOC View –setting of battery indicator format
(percentage/voltage)
TRIP reset – temporary data erasure (TRIP, MAX, AVG,
TIME)
AL Sensitivity –setting of light sensitivity (0 – 5, 0 =
switched-off sensitivity sensor)
Set Clock – time setting
Back – back
ITEM INFORMATION
Battery info – general information about the status and
attributes of the battery
Error Code – general information of carried-out error
reports (max. 10 items)
Back – back
Setting items can differ according to the version
of display software.
RANGE
TIME
Remaining
Total time
range
of the ride
Hide quick links:
Advertisement
Table of Contents
