Charging Of The Battery - Apache Tuwan MX1 User Manual

SEATPOST BATTERY
(Gaagii, Gaagii Lady, Wakita Tour, Wakita City, Tanka, Tanka Nexus, Tocho, Tocho Nexus)
Turning on: Turn the battery on with a switch in
the upper part of the battery.
Manipulation: To take out the battery, first pull
the seat post and seat out of the frame. The lock
is in the bottom part of the battery. Turn the key
into the UNLOCK position and take the battery
out by grabbing the handle and pulling upwards.
Insertion of the battery is done reversely. Put
the battery with the groove on the leading
batten, or it won't go all the way down. Insert
battery
switch

CHARGING OF THE BATTERY

ADVICE
Lithium batteries do not have a memory effect, so you can charge them whenever, ideally after
every e-bike use. Considering the automatic discharging that leads to slow loss of capacity,
we recommend, in case of long-term storage, to regularly check this and in case of decrease in
capacity recharge it to recommended level of 60-80 % of its total capacity.
Battery can be charge either directly on
the bike or you can take it out and recharge
separately. Always turn the battery off before
the recharge. Charge it in a dry environment.
Charging connector isn't protected against
splashing water. Recharge the battery ideally
in room temperature (15-20°C). Recharging
in temperatures lower than 0°C or higher
than 40°C can lead to serious damage to
battery.
carefully not to damage the connector by sharp
impact. To secure the battery turn the key to the
LOCK position and take it out.
Ascertaining state of charge of the battery:
via LED indicator placed on the upper part of
the battery that is activated via press of the
button. Battery must be on. It is on full capacity
if 4 LED diodes are glowing (3 green, 1 red).
If only red LED diodes is glowing, battery is
almost flat and need to be recharged as soon as
possible.
unlock
locked
PROCEDURE
First connect the charger to the battery, then
connect the charger to a power source (230V)
and wait until the LED diode on the charger
glows red. That signalizes that Charging is
underway. Charging stops automatically when
the battery is fully charged, still we recommend
to disconnect the charger from battery and
power as soon as it is done. Diode signalizing
charging will glow green. Interruption of the
process doesn't damage the battery.
stav baterie
13