Parameters Setting; Error Messages - Apache Tuwan MX1 User Manual

WALKING ASSISTANT
Walking assistant can be activated by pressing
C
and holding the
For activation of the assistant assistance mode
must be set to 1-5. This function serves to enable
easier manipulation with e-bike, usually when
walking the bike by your side. The e-bike speed
will be between 4 and 6 km/h. Walking assistant
will be turned off immediately after letting go of
the button.
TRIP
Lenght of the trip
ERASING TEMPORARY DATA
To erase the temporary data (trip, time, avg, max)
twice push the button
display. Pick option
and confirm with button

PARAMETERS SETTING

To enter the mode of parameter setting press
M
twice the button. To change a parameter,
A
use buttons and
parameter press the
rES – reset of daily kilometres
Un – unit setting (km / mile)
Ld – setting of the bike circumference in cm (max. +/- 5 % from the default setting of the circumference)
bL – display backlight setting in 1-3 range
Ls – speed limit; value 20 means max. assisted speed of 25 km/h
SPS – wheel speed sensor signal
Cr – value of the electric current
ERROR
Code
MESSAGES
0X0000
0X0001
0X0002
0X0004
0X0008
0X0010
0X020
0X0040
0X0080
0X0100
0X0200
0X0400
0X0800
0X1000
If the error remains or a different one shows, contact your seller.
6
button on the control display.
ODO
Total distance
M
. rES will show on the
M A
with buttons and
M
.
C
and for saving the set
M
button.
Cause of the problem
no error
controller power tube or over current
controller over heat
motor phase
motor hall
motor over heat
low voltage protection
stall protection
throttle
over-speed beyond control
battery communiction
pas sensor
speed sensor
display communication
L WARNING: Do not block the e-bike
after the activation of the walking
assistant. The motor can get damaged
that way.
SPEED AND DISTANCE INDICATOR MODE
CHANGE
Change of information displayed on the display
can be done by short press of the button
Information shows in this order:
TIME MAX
Time* Maximum speed
TURNING ON THE LIGHTING
(IF IT IS INSTALLED)
Turning on the front and rear light is done by
C
pushing and holding the
USB PORT
The display is equipped with a micro USB port
for charging of mobile devices (5V/0,5W).
To connect your device with the charging
connector, use any adapter or cable with Micro
USB-B connector.
M
.
AVG
Average speed
A
button for 1 second.