Apache Tuwan MX1 User Manual page 4

BASIC INFORMATION
FOR E-BIKE USE
IMPORTANT!
Check the functionality of brakes and state
of charge of the battery before every ride.
Always wear a cycling helmet when riding an e-bike!
RIDING AN E-BIKE
You can ride an e-bike the same way as a normal
bike. You just have to drive off and pedal. Motor
will activate itself after the cranks start turning
and works according to set assistance mode.
The motor turns itself off automatically if the
rider brakes. This is not true for models with
hydraulic disc brakes, as their levers are not
equipped with all necessary sensors.
IMPORTANT!
Long-term riding with low motor speed and high mode of assistance can lead to overheating
and, in case of excessive load, even to damage of the motor. If this happens, we strongly
recommend to reduce the mode of assistance.
E-Bike's function can be influence by external electromagnetic forces (i.e. radars, etc.).
ADVICE
In case of troubles with changing gears to lighter or heavier gear we recommend additional
installation of "Gear sensor" that disables the motor for a short while during the gear change.
The gears then don't change while the motor is using its full power, which is considerate not only
to the motor itself, but also to other components.
4
Motor of these models turns off after two
seconds after you stop pedalling.
Once you reach the speed of 25 km/h, the motor
automatically turns itself off and activate again
when the speed goes under this limit.
Motor also doesn't work when you're not
pedalling or turning cranks backwards.