Troubleshooting - Tecomec SHARP BOY Owner's Manual

sharpened.
- Block again with the handle M19 and sharpen.
24. SHARPENING THE DEPTH GAUGE (FIG. 20)
- The depth of the depth gauge normally needs restoring
after the cutter has been sharpened 2 or 3 times. To do
this, grind material from the depth gauge itself using an
appropriate flat file (not supplied with the machine).
- Check if the gauge depth is correct, using the template
with the shape related to the type of chain used. Please
also consult the chain table, (column F).
25. STOPPING AND SHUTTING DOWN
25.1 STOPPING
Unplug the power cable from the mains.
25.2 SHUTTING DOWN
Once you have finished using the machine, disconnect it
and clean it thoroughly.
Store it in a dry and safe place, protected against dust and
damp.
25.3 ROUTINE MAINTENANCE
Follow the instructions given in the "STOPPING"
section before you start to work on the machine.
Maintenance interval
When the grinding wheel
reaches a minimum diameter
of approximately 85 mm
(3.34 in)
40 hours
25.4 HANDLING AND TRANSPORT
- If you need to transport the machine, take it off the bench
or wall, dismantle the grinding wheel and put all the parts
in a packing box to protect them against impact.
25.5 DEMOLITION AND DISPOSAL
The machine is to be demolished by qualified personnel
in compliance with current laws in force in the country in
which it is installed.
The symbol (on the rating nameplate) points out that
the product must not be disposed of with normal household
garbage. Contact an authorized service centre or your dealer
10
Job
Replace the grinding wheel.
Clean the grinder thoroughly
using a rag or a cleaning
brush.
Do not use compressed air.
EN
for disposal instructions.
Before you scrap the machine, make it unusable (by
cutting the power supply cable for example) and make
the parts safe, which could cause a source of danger
for children if they should play with the machine.
26. TROUBLE SHOOTING
Follow the instructions given in the "STOPPING"
section before you start to work on the machine.
- Contact a skilled technician if you are still unable to
restore the correct operation of the machine following the
instructions given in the chart.
Problem Probable cause
The thermal
switch has
tripped.
One of the safety
devices of the
The machine fails system to which
to start when you the machine is
press the switch. connected has
tripped (fuse, cir-
cuit breaker etc.)
The machine is not
plugged into the
mains properly.
The machine is not
secured correctly.
The vise unit is not
T h e m a c h i n e
secured correctly
vibrates abnormally.
to the base unit.
T h e g r i n d i n g
wheel is not fitted
correctly in its seat
on the hub.
Solution
Wait for the motor
cooling down and
for the device rset.
Reset the safety
device.
Unplug and plug in
again properly.
Check it is secured
properly and, if
necessary, tighten
t h e s e c u r i n g
screws correctly.
Tighten the related
blocking handle
correctly.
D i s m a n t l e t h e
grinding wheel,
check its integrity
and fit it again
correctly.