Projecting An Image (Basic Operation); Turning On The Projector - Canon LV-7240 User Manual

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER button.
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
2. Press the POWER button on the projector cabinet or
the POWER button on the remote control for a
minimum of 2 seconds. The POWER indicator will
turn to green and the projector will become ready to
use.
After you turn on your projector, ensure that the
computer or video source is turned on and that your
lens cap is removed.
NOTE: When no signal is available, a blue, black or logo screen is
displayed.
When the projector displays a blue or a black screen (not logo),
the Quiet mode will be automatically selected in "Lamp Mode."
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans runs without
displaying an image for some time and then the projector will
display the image.
52 for more
Standby
LAMP REPLACE
WARNING
POWER
Steady orange light
See page
20
LAMP REPLACE
WARNING
POWER
IN
A C
LAMP REPLACE
WARNING
POWER
VIDEO
VOL VOL
-
+
OFF POWER
NO SHOW
D.ZOOM PAGE
MENU
Blinking
LAMP REPLACE
WARNING
POWER
Blinking green
light
52 for more details.
S-VIDEO
Power On
LAMP REPLACE
WARNING
POWER
Steady green
light