Projecting An Image (Basic Operation); ❶ Turning On The Projector - Canon LV-7265 User Manual

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.
❶ Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a POWER button.
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off ( ) po-
sition. Failure to do so may cause damage to the projector.
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
2. Remove the lens cap.
3. Press the POWER button on the projector cabinet or
the POWER button on the remote control for about 1
second.
The POWER indicator will turn to green and the projec-
tor will become ready to use.
After you turn on your projector, ensure that the com-
puter or video source is turned on and that your lens
cap is removed.
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans runs without
displaying an image for some time and then the projector will dis-
play the image.
CAUTION:
The projector cannot be turned off for 60 seconds after
the lamp is turned on and while the POWER indica-
tor is blinking green. Doing so could cause premature
lamp failure.
60 for more
See page
23
http://www.pureglare.com.au
WARNING
LAMP
WARNING
IN
AUT
LAMP
Standby Blinking
WARNING WARNING
LAMP LAMP
S t e a d y o r- Blinking
ange light green light
60 for more details.
POWER INFO.
IMAGE INPUT AUTO PC
ASPECT NO SHOW
MENU
Power On
WARNING
LAMP
Steady
green light