Appendix; Troubleshooting - Canon LV-7240 User Manual

7. Appendix

Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.
Indicator Messages
POWER Indicator
Indicator Condition
Blinking light Green
Orange
Steady light Green
Orange
WARNING Indicator
Indicator Condition
Blinking light Red
Green
Steady light Orange
LAMP REPLACE Indicator
Indicator Condition
Blinking light Red
Steady light Red
Green
Off
0.5 sec On,
0.5 sec Off
2.5 sec On,
0.5 sec Off
0.5 sec On,
0.5 sec Off
Off
1 cycle (0.5 sec On,
2.5 sec Off)
2 cycle (0.5 sec On,
0.5 sec Off)
4 cycle (0.5 sec On,
0.5 sec Off)
6 cycle (0.5 sec On,
0.5 sec Off)
Off
Projector Condition
The main power is off
The projector is getting ready to turn on.
Off Timer is enabled.
The projector is cooling down.
The projector is turned on.
The projector is in Standby.
Projector Condition
Normal
Lamp cover error or lamp housing error
Temperature error
Fan error
Lamp error
Re-firing the lamp (The projector is cool-
ing down.)
Key lock is On.
Projector Condition
Normal
Lamp has reached its end of life. Lamp
replacement message will be displayed.
Lamp has been used beyond its limit. The
projector will not turn on until the lamp is
replaced.
Lamp mode is set to Quiet mode
52
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
Note
–
Replace the lamp cover or lamp
housing correctly.
The projector is overheated. Move
the projector to a cooler location.
Fans will not work correctly.
Lamp fails to light. Wait a full
minute and then turn on again.
The projector is re-firing.
Wait for a moment.
You have pressed cabinet button
when Key lock is On.
Note
–
Replace the lamp.
Replace the lamp.
–