Advertisement
Installation
1. Installing the electrostatic sticker.
Clean your windshield and put the electrostatic sticker on the
recommended area as shown in the figure. Make sure you remove
air bubbles between the sticker and the glass.
Note: Make sure to stick the electrostatic sticker on a flat and smooth part of the windshield, press it firmly,
and avoid sticking it on the edge of the windshield's film to prevent it from falling down.
2. Installing the memory card.
Insert the memory card into the card slot with its contacts facing
up until you hear a click. The memory card is well-installed.
3. Installing the mount.
Attach the mount to the slot and slide up, as shown in the figure.
You will hear a snap when it is in place. Make sure the mount is
securely installed to the dash cam.
2
4. Mounting the dash cam.
Peel off the protective film from the adhesive sticker on the base of the
mount, and paste the dash cam onto the electrostatic sticker in the
dotted area.
5. Connecting the power supply.
As shown in the figure, run the power cord along the top of the
windshield, down the A-pillar, and around the glove compartment,
so that the power connector is near the cigarette lighter. Connect the
power cord to the car charger, then plug the charger into the cigarette
lighter socket.
Note:
Use the included crowbar to hide the power cord underneath the vehicle's headliner and rubber seal
●
along the A-pillar.
Depending on the vehicle, the cigarette lighter socket may be located in a different position. The above
●
figure is for reference only.
6. Adjusting the dash cam angle.
Turn on the dash cam and adjust the camera angle based on the preview
screen to ensure that the camera is facing the front of the vehicle.
3
Advertisement
