Moving The Heater - Honeywell HCE870 Series Owner's Manual

ABOUT CERAMIC TECHNOLOGY
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
This type of heating technology provides fast, even heating.
The Thermawave™ 6 Heater was designed for maximum heat output.
ASSEMBLY
This heater requires simple, no tool assembly.
Unpack Main Body and Mounting Base (Fig. 1).
Place Mounting Base on a firm surface. Place ThermaWave
Base so Mounting Tabs are aligned with Base Slots. Press Main Body onto the Base until Tabs snaps secure
into the Slots (Fig. 2).
Fig. 1
SET-UP
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9 m) away from
any wall or combustible material. DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE A TRIPPING HAZARD.
For best result, place heater on the floor to create warming room convection and allow heater to run for 5-10
minutes to reach maximum heat output.

MOVING THE HEATER

Turn off the heater.
Allow it to cool for ten (10) minutes.
Unplug heater and move. This heater is equipped with a Cool Touch Handle for your convenience.
6 Heater Main Body on Mounting
TM
Fig. 2
4