Canon SELPHY ES1 User Manual page 16

Printer
Please avoid turning the printer's power on and off needlessly as the printer
initialization consumes ink.
There may not be enough ink left for the allotted sheets in the set.
Never use volatile compounds or insecticides on the printer, and do not allow rubber or
vinyl material to remain in prolonged contact with the printer.
These materials may cause deformation of the printer's casing.
If the printer overheats, it will temporarily stop operating. This does not mean that the
printer has malfunctioned.
The printer will resume normal printing as soon as it cools down.
Temporary stoppages are most likely to occur in the following cases:
• When printing continuously.
• If the room is unusually warm.
• If the air vents on the back of the printer are blocked or if ventilation is inadequate.
Lower the carrying handle when printing. If the prints touch the carrying handle then
printing may not be done correctly.
If the print receptacle cover comes off, insert the
shaft on the right side of the cover into the
printer ( ) and then align the tip of the spring
1
on the left side of the cover with the groove on
2
the printer ( ). If the print receptacle cover is
2
1
not attached during printing, paper that is
finished printing may get jammed inside the
printer.
Do not close the print receptacle cover when
printing. If closed accidentally, press the print
receptacle button to open the print receptacle
cover.
Do not insert foreign objects into the print receptacle.
Do not open the cartridge cover during printing.
If you do so, printing will stop and the paper currently being printed will not be completely
printed.
Cartridge
Please use only the cartridge type specified for use by Canon.
Do not touch or pull on the ink sheet.
There may not be enough ink left for the allotted sheets in the set.
Do not handle the cartridge with wet or sweaty hands.
Do not apply excessive force to the cartridge.
Do not remove the protective paper from the cartridge or do not press down hard on the
paper.
Force or impact on the paper may result in paper jams or equipment damage.
14