Phanteks GLACIER G30 STRIX 3090 Installation Manual

GLAC IER G30 STRIX
PH-GB3090ASSRX_BK01/CR01
PACKAGE CONTENTS
GLACIER GB3090ASSRX
QTY: 1
GLACIER Stop Fitting
QTY: 2
WARNING -
been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in
the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
STEP 1. REMOVING STOCK COOLER
Unscrew all highlighted screws to remove
the stock cooler, backplate and heatsink.
backplate screws
stock cooler screws
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
Take the EVA-Foam from the box to use
as a base for your installation process.
STEP 2. APPLYING THERMAL PASTE & PADS
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip
the thermal pads on correct position on
the PCB.
both sides of the thermal pads.
RTX
Thermal Pads
4 4 4 4 4 4 4 4 4 4 4
1 1 1 1 1 1 1 1 1 1 QTY: 3
2 1 1
3
5
6
M2.5x5 Screws/Washers
QTY: 15/15
STRIX RTX 3090
4 4 4 4 4 4 4 4 4 4 4
1 1 1 1 1 1 1 1 1 1
2 1 1
3
5
6
STRIX RTX 3080
4 4 4 4 4 4 4 4 4 4 4
1 1 1 1 1 1 1 1 1 1
2 1 1
3
5
6
3090/3080
INSTALLATION GUIDE V1.1
For latest version check www.Phanteks.com
4 １ １ １
１
１
5 2
１
１
4
4
4
１
１
5 2
１
１
4
4
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks D-RGB Cable
QTY: 1
4
１ 4
4
１
3 6
4
１
１
4
4
１
4
4
１
１ 4 4
4
１
3 6
4
１
１
4
4
１
4
4