Assembly - YARDMAX YF1565 Operator's Manual

This walk-behind blower was partially assembled at the factory. To assemble your machine follow the below instructions.
FRAME
Insert the end of the front swivel caster tube into the opening of
the frame tube, and align the holes.
Attach the tubes to the engine deck with M8x40 bolt, arc washer,
spring washer and lock nut in four places. Tighten securely using
Figure 2)
two 13mm wrenches. (See
WHEELS
Install one spacer onto the wheel axle.
Slide the wheel onto the axle.
Secure the wheel in place with a flat washer and a cotter pin on
the outside. Bend and spread the cotter pin prongs in opposite
directions.
Repeat these steps to install the 2nd wheel. (See Figure
I

Assembly

9
ASSEIMBLY
Figure2
ml
M8 x 40
x 4
3)
Figure3
SWIVEL CASTER
Install one bushing onto the underside (bottom side) of the swivel
caster bracket opening, with the smaller end of the bushing facing
up.
Install the caster by pushing the caster tube up through the
bracket opening.
Install the 2nd bushing onto the shaft and insert it into the top of
the caster bracket opening, with the smaller end of the bushing
facing down.
Secure the swivel caster to the caster tube using a flat washer,
spring washer and acorn nut. Tighten securely using a 16mm
wrench. (See Figure
4)
Figure4
x2 -----