Honeywell Home VisionPRO 8000 Smart TH8321WF1001 User Manual page 14

Initiating occupancy mode: commercial use
This feature keeps temperature at an
energy-saving level until you touch Press
HERE
to Start Occupancy. When you
arrive, touch the message to maintain a
comfortable temperature while the room is
occupied.
Touch the s or t buttons to set the
temperature or the Hold Until time. The
temperature is maintained until the time
you set. Temperature returns to an energy-
saving level after the timer expires, or the
"Occupied" period ends.
NOTE: This feature is available only when
programmed by the installer.
Adjusting humidification settings
1 Touch MENU and select Humidification.
2 Select Auto.
3 Touch s or t to select humidity level.
4 Touch Done to save your settings. Touch Cancel
to ignore changes.
5 If frost or condensation appears on the
windows, touch MENU, then select Window
Protection. (Use a lower number to prevent frost
or condensation. Use a higher number if indoor
air is too dry.)
NOTE: Window (frost) Protection is available
only if an outdoor air sensor is installed OR if
using the outdoor temperature from the Wi-Fi
connection to get local outdoor weather data
from the Internet.
NOTE: The thermostat controls humidification
and dehumidification as needed to maintain
the desired humidity level. Depending on how
your thermostat was installed, the thermostat
may maintain a 15% separation between
humidification and dehumidification settings.
33-00066EFS—05
Start Occupancy
Window Protection
12
Press HERE to
MCR34100
Humidification
MCR34128
Humidification
Off Auto
MCR34129
M34127