Britax BOB Gear ALTERRAIN User Manual page 8

BOB Gear
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, (A)pull the release
lever, and (B)pull the wheel out
of the rear wheel attachment
bracket. Repeat for the other side.
Front Wheel Installation
1. Remove Through-Axle and Hex
Wrench From Storage Bag
Remove nut from through-axle.
Through-
Nut
Axle
2. Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 10.
6
3� Insert Front Wheel
4� Insert Through-Axle
Hex
Wrench
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with holes in the fork blades.
(A) Insert the through-axle
through the wheel hub,(B) then
install the tension adjusting
nut on the opposite side. The
washer should remain on the
outside portion of the fork
dropout when tightening.