Table of Contents
Advertisement
Quick Links
4/12/2017
Receiving instructions:
After delivery, remove the packaging from the product. Inspect the product closely to determine whether
it sustained damage during transport. If damage is discovered, immediately record a complete description
of the damage on the bill of lading. If the product is undamaged, discard the packaging.
Note:
The end-user is solely responsible for confirming that product design complies with all laws, regulations,
codes, and mandatory standards applied where the product is used.
Signal Words...................................................................................................................................2
Hazards of Improper Use...................................................................................................................2
Introduction.................................................................................................................................... 3
Installation....................................................................................................................................... 3
Stretch Wrap Holder Assembly.......................................................................................................... 4
Belt Tensioning Procedure................................................................................................................ 5
Operation...................................................................................................................................... 5 - 7
Exploded Parts Views & Bills of Materials............................................................................................. 8 - 10
Labeling Diagram............................................................................................................................. 11
Inspections & Maintenance................................................................................................................12
Troubleshooting............................................................................................................................... 1 3
Electrical Circuit Diagrams................................................................................................................14 - 15
Limited warranty.............................................................................................................................. 16
Copyright 2017 Vestil Manufacturing Corp.; All rights reserved
SWA-48 and SWA-48-PMO
Instruction Manual
SWA-48
Table of Contents
Vestil Manufacturing Corp
www.vestilmfg.com
SWA-48, MANUAL
SWA-48-PMO
Page 1 of 16
Advertisement
Table of Contents
Related Manuals for Vestil SWA-48
Summary of Contents for Vestil SWA-48
-
Page 1: Table Of Contents
Operation……………………………………………………………………………..……………………………..………. 5 - 7 Exploded Parts Views & Bills of Materials………………………………………………………………………..….…... 8 - 10 Labeling Diagram………..……………………………………………………………………………………………..….… 11 Inspections & Maintenance…………………………………………………………………………………………..…..12 Troubleshooting……………………………………………………………………………………………...……..….……. 1 3 Electrical Circuit Diagrams………………………………………………………………………………………………….14 - 15 Limited warranty……………………………………………………………………………………..………...…………..16 Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 1 of 16... -
Page 2: Signal Words
If this product is used improperly or carelessly, personal injuries might result. DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. Unauthorized modifications automatically void the Limited Warranty and might make the product unsafe to use. -
Page 3: Introduction
SWA-48, MANUAL Introduction Vestil's Medium Duty Powered Stretch Wrap Machines offer the same great features as our standard duty machines in a 5,000-lb capacity unit. Complete with a powered turntable and counter-balanced stretch film mast. To operate, depress the foot pedal and manually move the mast up and down. The film-wrap tension is controlled with an adjustable, friction-brake assembly. -
Page 4: Stretch Wrap Holder Assembly
Tube retainer (bottom) 20-014-005 Tube retainer (top) 20-110-002 Bearing, ball, in., shield 68061 in. retainer ring 20-113-022 Spacer, lock 20-113-003 in. fiber washer 20in. plastic wrap (not SRF-18 included) Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 4 of 16... -
Page 5: Belt Tensioning Procedure
Ensure that all employees involved in the operation and care of this machine understand and follow these instructions. The standard model SWA-48 is suitable for moderate-duty, intermittent cycling with a 4,000 pound load. It is intended to be used indoors in industrial and commercial locations to apply stretch-wrap material at between three and twelve revolutions per minute (RPM) in a clockwise rotation around palletized, stable, non-hazardous loads. -
Page 6: Operation
The following screen, , will appear. This indicates the specific parameter group. Use the following keys, shown on the next page, to change all parameter settings in Step 2. Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 6 of 16... - Page 7 Affects the drive's motor slip compensation. 7-01 Motor No-load Current d 75 Controls the motor's maximum start-up torque. 7-02 Torque Compensation d 10 Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 7 of 16...
-
Page 8: Exploded Parts Views & Bills Of Materials
4/12/2017 SWA-48, MANUAL SWA-48 Exploded Parts Diagram and Bill of Materials Item Part no. Description Qty. Item Part no. Description Qty. 20-514-006 Weldment, main frame 20-042-020 Belt, B115 20-513-001 Weldment, turntable deck 20-016-032 Bracket, motor mount, formed Subassembly, control 20-542-006 Weldment, pulley/pin... - Page 9 4/12/2017 SWA-48, MANUAL SWA-48-PMO Exploded Parts Diagram and Bill of Materials Item Part no. Description Qty. Item Part no. Description Qty. Split lock washer, carbon steel, 20-514-006 Weldment, main frame 33622 medium zinc finish, ” 20-513-001 Weldment, turntable deck...
- Page 10 20-113-003 in. fiber washer 20-014-005 Frame, tube retainer, (top) 68061 in. retainer ring 20-014-006 Tube, retainer, (bottom) 20-111-002 Bearing, 7R16 20-014-116 Frame, rod, wrap retainer 20-113-022 Spacer, lock Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 10 of 16...
-
Page 11: Labeling Diagram
4/12/2017 SWA-48, MANUAL Labeling Diagrams: SWA-48 SWA-48-PMO A: Label 248 B: Label 221 C: Label 204 D: Label 287 E: Label 220 Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 11 of 16... -
Page 12: Inspections & Maintenance
Such damage is not covered under warranty. The gear reducer uses. Disassembly of the gear reducer will void the warranty, and at the manufacturer’s discretion may void all warranty of the stretch- wrap machine. Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 12 of 16... -
Page 13: Troubleshooting
• Inspect for foreign material or objects that might • Control relay 2 CR is defective. block the carriage path. • Bad connection in control circuit. • Physical blockage of the structure. Copyright 2017 Vestil Manufacturing Corp.; All rights reserved Page 13 of 16... -
Page 14: Electrical Circuit Diagrams
4/12/2017 SWA-48, MANUAL SWA-48 Electrical Circuit Diagrams (20-124-012 Rev. G) Disconnect the unit from electrical power before beginning work on the electrical system. Only qualified, trained individuals should attempt troubleshooting and repair of this equipment. Copyright 2017 Vestil Manufacturing Corp.; All rights reserved... - Page 15 4/12/2017 SWA-48, MANUAL SWA-48-PMO Electrical Circuit Diagrams (20-124-015 Rev. J) Disconnect the unit from electrical power before beginning work on the electrical system. Only qualified, trained individuals should attempt troubleshooting and repair of this equipment. Copyright 2017 Vestil Manufacturing Corp.; All rights reserved...
-
Page 16: Limited Warranty
(you) for warranty service. Who may request service? Only a warrantee may request service. You are a warrantee if you purchased the product from Vestil or from an authorized distributor AND Vestil has been fully paid.
Need help?
Do you have a question about the SWA-48 and is the answer not in the manual?
Questions and answers