Layout And Items Supplied - EINHELL TC-RH 800 4F Original Operating Instructions

firmly locked in the chuck before you start
work.
•
Check the chuck for wear or damage at re-
gular intervals.Do not start a hammering tool
until it is pressed against a workpiece (wall,
ceiling, etc.).
•
Always unplug the rotary hammer when you
have finished working and remove the chisel
bit or drill bit from the tool.
•
Always unplug the machine before changing
chisel bits or drill bits etc.
•
Protect eyes and assistants from small flying
parts and splinters. Wear a helmet! Erect a
screen wall!
•
Use workgloves to protect fingers from crus-
hing and skin from grazing.
•
Vibrations can be harmful to the hand-arm
system: Keep the impact time of vibrations to
a minimum.
•
Always keep the power cable away from whe-
re you want to drill.
•
Keep the machine out of children's reach.
•
Always hold the machine with two hands
when it is running and make sure of your
footing.
•
Make sure that the switch on the machine is
set to the correct position for the work you
want to perform before you put the machine
into opera-tion. If the switch is not in the cor-
rect position you risk suffering bodily injury
when the machine starts to run.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Do not lose these safety instructions
Anl_SA_TC_RH_800_4F_SPK8.indb 25 Anl_SA_TC_RH_800_4F_SPK8.indb 25
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Dust guard
2. Locking sleeve
3. Selector switch for drill/hammer drill/chisel
4. ON/OFF switch
5. Locking button
6. Additional handle
7. Depth stop
8. Handle
9. Clockwise/Counter-clockwise switch
2.2 Items supplied
Please check that the article is complete as
specified in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suffocating!
•
Rotary hammer
•
Additional handle
•
Depth stop
•
Original operating instructions
- 25 -
31.05.2021 09:52:36 31.05.2021 09:52:36