Download Print this page

Balancing The Washing Machine; Installation Of The Drain Hose - Haier HWT07AN1 User Manual

Top load full-automatic washing machine
Hide thumbs


Installation & Adjustment
Balancing the
Installation on an uneven surface can lead to 'out of balance' events, instability in the machine
operation, or even failure to successfully complete a wash cycle.
Please refer to the following methods for adjustment:
1.Confirm whether the machine is level.
2. Lift the lid and ensure that the bowl is central to the top deck opening.
Adjust the two front leveling feet as necessary.
Note:The distance between the washing machine
and the wall should be at least 20mm.
Not level
Drain hose
1. Remove the cap of the drain hose outlet.
Note: A small amount of water may come out when the cap is removed. This is
normal as there maybe some water left in the pump as the
machine is tested during manufacture.
2. First connect the drain hose to the connection
point on the lower right side of the cabinet, and fasten
with drain hose clamp (provided).
3. Connect drain hose guide on to the outside of
drain hose. To guide the drain hose over the
tub or standpipe, the bracket MUST be fitted
to the drain hose.
1.The height of the standpipe or tub should be
between 0.8 - 1.2 m.
2.To avoid syphoning, the drain hose should not
extend more than 20 mm from the end of the guide.
Ensure drain hose is held in place to avoid
leaks or spills.
washing machine
Drain hose
Drain hose joint
0.8 m h



  Related Manuals for Haier HWT07AN1

This manual is also suitable for: