Table of Contents
Advertisement
U s i n g t h e D C P 5 0 1 T u n e r
This section describes:
How to tune radio stations
How to Program the DCP501 to tune to your favorite stations with the preset option
Tuning Radio Stations
To tune the radio on the DCP501:
Press
to tuner or press
SOURCE
1
The last radio station tuned
The radio band—AM or FM (also shown on your TV)
The preset number assigned to that station if one has been assigned
Press
/
to select the radio band.
AM
FM
2
Press
on the front of the DCP501 or (
TUNE
3
frequency. The frequency changes in 200kHz steps in FM and 10kHz steps in AM. Press and
hold
on either the DCP501 front panel or the DCP501 remote control and DCP501
TUNE
display
icon turns on and the DCP501 scans to the next radio station.
A U T O
If the tuned signal received is strong, the
the
icon also turns on. If the signal is weak,
S T
improve the sound, which causes the receiver to operate in monaural (mono) mode, and the
icon turns off. Press
S T
Presetting Radio Stat ions
You can enter up to 30 preset stations to quickly access your favorite radio station. The 30
stations can be assigned to any combination of AM and FM stations that you would like. To
preset radio stations with the DCP501 tuner:
Tune to the desired radio station.
1
Press
or
. The
SELECT
OK
2
below it, for example
Press
/
CHANNEL
PRESET
3
directly enter the preset number using the numeric buttons on your DCP501 remote control.
Press
or
SELECT
OK
4
flashing.
A new preset can be stored over an old one by following the same procedure.
/
. The DCP501 displays:
AM
FM
T U N E D
/
again to return to stereo operation.
AM
FM
icon flashes at the same time as the station number
P R E S E T
.
1 0 5 . 3
to select the desired preset number to store the station on or
to accept your changes. The
O p e r a t i o n
) on the remote control to change the
icon turns on. For a stereo FM station,
(stereo) flashes. Press
S T
icon and the preset number stop
P R E S E T
7 9
to
FM MODE
DCP 501 U ser Gu i d e
Advertisement
Table of Contents
