Brother DCP-145C User Manual page 72

Error Message Cause
The machine is out of paper or
No Paper Fed
paper is not properly loaded in the
paper tray, or the Jam Clean Cover
is not closed properly.
The paper is jammed in the
machine.
The machine's memory is full.
Out of Memory
The memory card or USB Flash
memory drive you are using does
not have enough free space to scan
the documents.
Paper is jammed in the machine.
Paper Jam
The machine has a mechanical
Print Unable XX
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
Scan Unable XX
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
A broken device has been
Unusable Device
connected to the USB direct
interface.
A USB device or USB Flash
Unusable Device
memory drive that is not supported
Please Disconnect
has been connected to the USB
USB Device.
direct interface.
For more information, visit us at
http://solutions.brother.com.
Paper is not the correct size.
Wrong Paper Size
64
Action
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Colour Start.
Remove the paper and load it again and then
press Mono Start or Colour Start. (See
Loading paper and other print media
on page 8.)
See Printer jam or paper jam on page 66.
When copy operation is in progress, press
Stop/Exit and wait until the other operations in
progress finish and then try again.
Delete unused files from your memory card or
USB Flash memory drive to make some free
space and then try again.
Remove the jammed paper by following the
steps in Printer jam or paper jam on page 66.
See Printer jam or paper jam on page 66. Make
sure the paper length guide is adjusted to the
paper side.
Open the scanner cover and look on the left,
middle and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Open the scanner cover and look on the left,
middle and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Unplug the device from the USB direct interface,
then press On/Off to turn the machine off then
on again.
Unplug the device from the USB direct interface.
Make sure the machine's Paper Size setting
matches the size of paper you are loding in the
tray. Load the correct size of paper, and then
press Mono Start or Colour Start.