Define / Alter Pin - Honeywell IDENT KEY 3 Operating Manual

28
8.8

Define / alter PIN

Use the "i" key for this function, otherwise other combinations would immediately trigger an action if a
IK data carrier is held in the reading range.
A PIN is allocated to the corresponding IK data carrier (or multiple use of a PIN, see Chapter 9
"Appendix".)
Acknowledgement is negative if there is no authorization, if an attempt is made at defining an already
existing PIN (not with multiple use) or the PIN corresponds with a hold-up code.
Observe the following when defining / altering PINs:
Possible number of digits of a PIN: 4 to 8 digits.
The minimum number of digits is determined by the installer in compliance with the VdS class.
If several PINs are used, they must all have the same number of digits.
Define PIN
Alter PIN
EU BUS-2
up to V03.02
0....9
0....9
EU BUS-2 with V03.02:
If PINs are used several times, the PIN alteration must be started with the IK data carrier (A). If the
alteration is started with PIN, a negative acknowledgement follows.
i
IK-D
3
0....9
3
0....9
3
A) or B)
i i
0....9
IK-D
3 3
0....9
3 3
0....9
3 3
Operating Manual IK3 Operating Unit with Keypad
Activate the " " key i
Hold the IK data carrier in the reading range
Current state is indicated (see "Info" 8.5)
Activate "OK"
"Alarm" indicator lights up green
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK"
"Alarm" indicator goes off
Activate the " " key i
Hold the IK data carrier in the reading range or enter
the PIN used so far
Current state is indicated (see "Info" 8.5)
Activate "OK"
"Alarm" indicator lights up green
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK"
"Alarm" indicator goes off