Honeywell IDENT KEY 3 Operating Manual page 29

Operating Manual IK3 Operating Unit with Keypad
Alter PIN with EU BUS-2 from V04.xx upwards and EU conv. from V01.xx upwards:
A) Start mode with IK
i
Activate the " " key
IK-D
Hold the IK data carrier in the reading range
3
Activate "OK", "Ready" indicator flashes 1x (partial admittance)
0....9
Enter current PIN, "Alarm" indicator lights up green (Alter PIN mode active)
0....9
Enter new PIN
3
Activate "OK"
Re-enter PIN
0....9
3
Activate "OK", "Alarm" indicator goes off, "Ready" indicator lights up for 2 sec.
B) Start mode with PIN:
i
Activate the " " key
0....9
Enter current PIN
3
Activate "OK", "Ready" indicator flashes 1x (partial admittance)
Hold the IK data carrier in the reading range
IK-D
"Alarm" indicator lights up green (Alter PIN mode active)
0....9
Enter new PIN
3
Activate "OK"
0....9 Re-enter PIN
3
Activate "OK", "Alarm" indicator goes off, "Ready" indicator lights up for 2 sec.
This step is only required, if multiple use of PIN is allowed.
data carrier :
i
i
29