Control Panels And Controls - Klarstein 10029781 Manual

Loading the Wine Cellar
• You may load your wine bottles in single or double rows while taking note of the following: if you do not have
enough bottles to fill your wine cellar, it is better to distribute the load throughout the wine cellar so as to
avoid "all on top" or "all below" type loads.
• Do remove or relocate adjustable wooden shelves to accommodate larger type of bottles or increase the
capacity of the cellar by stacking the bottles up when necessary. (See removing shelves)
• Keep smalls gap between the walls and the bottles to allow air circulation. Like an underground cellar air
circulation is important to prevent mould and for a better homogeneous temperature within the cellar.
• Do not over load your wine cellar to facilitate air circulation.
• Avoid obstructing the internal fans (located inside on the back panel of the wine cellar).
• Do not slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the wine cellar to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct air circulation.
• Do not move your wine cellar while it is loaded with wines. This might distort the body of the wine cellar and
cause back injury.
The LED displays by default the actual internal air temperature. In the event of a power interruption, all previ-
ous temperature settings are automatically erased and it will revert to the preset temperature settings.
Single Window Display Board
1. Window: Display shows the actual temperature.
2. Cycle Button: Press one time ,the inside temperature will reduce 1
degree Celsius,until down to the lowest,press one time,the tempe-
rature will back to the highest.
3. Press the button 3 seconds to power off or power on. Press the
button and the lamp turns on, the lamp will turn off once press
again.
Double Display Board
1. Energy Saving Mode: Press the button 3 seconds to enter (4) (digital countdown display 3, 2, 1. Press the button
for 0.9 seconds after the window just POP countdown numbers). Press the button (6) and (7) at the same time
to exit saving mode.
2. ON/OFF the power button: Press the button 3
seconds to power off (5) (digital countdown dis-
plays 3, 2, 1, press the button for 0.9 seconds
after the window just POP countdown numbers).
Remark: The other functions will turn off except
light switch when the power turns off. Press again
(without delay), the power turns on.
3. Lamp button: Press the button and the lamp
turns on, the lamp turns off press again.

Control Panels and Controls

16