Installation - Klarstein 10029781 Manual

Before first Use
Allow 24 hours before switching on the wine cellar. During this time we recommend that you leave the door
open to clear any residual odors.
Important: All models without front venting (air opening) are strictly for free standing only.
Location
The location you have selected for your wine cellar should:
• be unencumbered and well ventilated;
• be well away from any heat source and direct sunlight;
• not be too damp (laundry, pantry, bathroom etc.);
• have a flat floor;
• have a standard and reliable electricity supply
• have a surge protector fitted to the electrical outlet;
• Away from the microwave oven. Certain microwave ovens do not have wave interference shield. When
placed within 1 meter vicinity of the wine cabinet, they may affect the operation of the wine cabinet.
Placing in cold or hot temperature conditions may cause cellar's temperatures fluctuating, and it will not reach
the ideal one.

Installation

• Unpack and remove all of the protection and adhesive strips from the packaging around and inside the wine cellar.
• The wine cellar must be positioned such that the plug is accessible. Release the power cord. Move your wine
cellar to its final location. The wine cellar should be installed in a suitable place where the compressor will
not be subject to physical contact.
• Wine cellar must be leveled BEFORE loading your wines. Your wine cellar is equipped with 4 adjustable feet
to facilitate easy leveling. VINICOLE recommends that you tighten the back feet to the maximum and adjust
the front feet to level the wine cellar.
Hints on built-in Wine Cellars
• Built-in wine cellars are front venting but are not designed to be fully integrated behind a joinery door.
• Please follow the installation diagram when installing built-in wine cellars.No less than the minimum instal-
lation dimension, or it will affect the venting of cellar.
• Built-in wine cellars draw air from right of ventilation frame (some models from the rear) and expel through
left of ventilation frame under the front door.
• Built-in wine cellars have a power switch located on the control panel so power point location is not critical.
13
Installation