Installing The Usb Driver - Canon Powershot G1 Software Starter Manual

Installing the USB Driver

(Preinstalled Windows 98/2000 Systems Only)
Notes Regarding Installation
• The USB driver only needs to be installed the first time the camera is connected via the
USB interface. Installation is not required from the second time onward.
• Do not cancel the installation partway through. Allow the procedure to finish completely
before exiting. The camera may not operate correctly if the installation is incomplete.
• Read the "Troubleshooting the USB Driver Installation" section on page 55 if the
installation cancels itself during the procedure, if the installation does not proceed as
described in these procedures, or if you think that the drivers are not properly installed.
• Read the "Uninstalling the USB Driver" section on page 55 or 58 for instructions for
that procedure.
Installing the USB Driver into Windows 98
Windows 98 CD-ROM
• Your computer may prompt you to insert the CD-ROM containing your Windows
system software during the installation. Have the Windows disk handy in case it is
required.
1. Once you have attached the USB cable to the camera and computer, set
the camera to the mode for communicating with a computer.
Refer to Where to Find Instructions for Attaching Your Camera to a
Computer (
The "Add New Hardware Wizard" dialog will appear after a moment.
2. Read the dialog and click the [Next] button.
The dialog will change to the search selection dialog.
p. ii) for connection instructions.
Your camera model name
will appear here.
9