Switch Settings
SWITCH NAME
SENSE
(Rotary SW)
0
1
2
3
NOTE 1
MB (Toggle SW)
ON
NOTE 2
SW1
(Piano Key SW)
FF
4
3
2
1
ON
The figure in the SWITCH NAME column and the position in
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and
, the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/
unplugging the circuit card.
NEAX2000 IVS Retrofit System Guide
ND-71075 (E), Issue 1.0
SWITCH
SETTING
NUMBER
POSITION
For setting FP No.
0
0-3
1
2
3
4-F
UP
DOWN
1 - 3
OFF
ON
4
OFF
CHAPTER 2 INSTALLATION
Lamp Indications and Switch Settings
FUNCTION
For mounting this card in PIM0
For mounting this card in PIM2
For mounting this card in PIM4
For mounting this card in PIM6
Not used
For make-busy
For normal operation
Not used
For normal operation
Not used
in the SETTING POSITION
CHECK
Page 23