Part 2 : Installation - Modena Doppio Series User Manual Book

Please read this operation manual carefully before operating the appliance in order to use the
appliance properly and safely. Pay attention to the entire sign or warning explained on the pictures or
text.
1. Install the dispenser on an even and stable surface. A
minimum distance of 20 cm from the wall must be
provided.
2. Leave the appliance for 1 hour to stabilize the
refrigerant.
3. Insert the Z-pipe into the gallon and then cover it with
the lid.
4. Insert the gallon into the cabinet. Make sure it is
installed properly and close the door.
5. Connect the power cord to the power socket, and turn
on the red switch (heater) located behind the
appliance. Make sure that the socket/electric source
has been grounded to prevent electric leakage. Turn
on the switch located behind the appliance.
6. For initial use, the inside of the appliance must be
cleaned. Press the hot and cold water button. Make
sure the water dispenses out of the tap. After that, wait
around 20 minutes, then remove the gallon and drain
the water by opening the drain valve. Make sure the
power cord is unplugged from the power source when
draining the remaining water.
7. If the gallon is empty, turn off the red switch (heater)
before replacing it with a new one.
Attention :
- This appliance is designed for indoor use.
- Avoid placing the appliance in a humid, wet, and poor electrical installation because it can
cause an electric shock or fire.
- Do not place flammable objects near the dispenser.
- Do not expose the appliance to direct sunlight and rain because it can degrade its
performance and cause electrical leakage hazard.
- Do not connect this dispenser to the source of electric current or pressing the heating button if
there is no water in the tank or no water flows from the hot water tap if the button is pressed.
- Do not modify the power cord on the appliance or connect using extension cord to prevent
risks of short circuit and fire.
- Do not touch the back or the condenser to avoid electric shock.
- During a power outage, after the power returns, wait around 5 minutes before turning the
appliance on.
Part 2 :
Installation
5