Mitsubishi Electric MA-E100R-E Service Manual page 37

(13) Removing and Replacing Two Fans and Two Blower Motors
1 Remove the front case.
→ (See "(6) Removing the Front Case".)
2 Remove the nut and washer B from the fan case,
and then remove the fan and washer A. Remove
the upper and lower fans, nuts, and washers via
the same procedure.
→ (Removing and Replacing the Two Fans)
* Tightening torque when mounting the nut:
3.0 ± 0.1 N·m
3 Remove the four motor holder mounting screws,
and then remove the motor holder. Remove the
upper and lower motor holders via the same
procedure.
4 Remove the lead wire cover from the upper part
of the fan case, and then pull out the lead wire to
remove the blower motor. Pull out the lead wire
from the lower part of the fan case to remove the
blower motor.
→ (Removing and Replacing the Two Blower
Motors)
<Reference>
• There is a lead wire cover only on the upper part
and there is not any on the lower part. (See the
photo 4.)
Blower motor
3
4
Lead wire cover
Motor holder mounting screw
3
Motor holder
Motor holder mounting screw
Motor holder
3
Motor holder
Fan case
2
Washer A
2
Motor holder mounting screw
Motor holder mounting screw
37
Washer B
2
Fan
Fan
2
Washer A
Fan Washer B
Lead wire cover
4
Upper part of fan case
Blower motor
4
Lower part of fan case
Blower motor
Nut
Nut