Aqueon Betta Falls Setup Manual

Betta Betta
Falls Falls
1. 1.

Strong, Stable Surface

Strong, Stable Surface
place aquarium on place aquarium on
Make sure surface is level Make sure surface is level
• Place aquarium evenly on a level • Place aquarium evenly on a level
surface so that all sides of aquarium surface so that all sides of aquarium
are supported. are supported.
• Surface should be able to easily • Surface should be able to easily
support more than 50 lbs. support more than 50 lbs.
See reverse for additional information.
1. 1.
place aquarium on place aquarium on
Betta
Falls
Make sure surface is level Make sure surface is level
• Place aquarium evenly on a level • Place aquarium evenly on a level
surface so that all sides of aquarium surface so that all sides of aquarium
are supported. are supported.
• Surface should be able to easily • Surface should be able to easily
support more than 50 lbs. support more than 50 lbs.
4. 4.
Water to Filter Chamber Water to Filter Chamber
1. Strong, Stable Surface
add add
place aquarium on
Fill to "Max" level on indicator Fill to "Max" level on indicator
Make sure surface is level
• Slowly pour room-temperature water into • Slowly pour room-temperature water into
• Carefully pour rinsed gravel • Carefully pour rinsed gravel
• Place aquarium evenly on a level
lter chamber until it lls completely without lter chamber until it lls completely without
into middle of each aquarium. into middle of each aquarium.
surface so that all sides of aquarium
over owing in the aquarium chamber. over owing in the aquarium chamber.
are supported.
• Spread gravel evenly • Spread gravel evenly
• Once water in lter chamber has emptied, • Once water in lter chamber has emptied,
• Surface should be able to easily around aquarium bottom. around aquarium bottom.
check "Max" level indicator to see if more check "Max" level indicator to see if more
support more than 50 lbs.
• Gravel depth should measure • Gravel depth should measure
water should be added. If so, repeat step water should be added. If so, repeat step
about 1" from the bottom. about 1" from the bottom.
above until water level reaches "Max". above until water level reaches "Max".
Strong, Stable Surface Strong, Stable Surface