Step 4
Slide the magnet across the aquarium smoothly
to remove algae. Move both horizontally and
vertically during cleaning. Be careful while
cleaning near the bottom of the aquarium, as
gravel and sand can become trapped between
the cleaning pad and the aquarium wall,
potentially causing scratching. For best results,
clean only within 1/2" of the substrate with the
ProMag. Use a scraper, such as a KENT Marine
Pro Scraper, to clean closer to the substrate.
NOTE: If cleaning pad comes in contact with
substrate, replace to avoid potential scratching.
Step 5
Moving the magnet too quickly, going around
corners and contact with objects inside the
aquarium can cause the inside and outside
magnets to separate. To reconnect the magnets,
hold the outside magnet close to the aquarium
wall near the inside magnet. If the inside magnet
has fallen too far from the aquarium wall or is
being blocked by an object, tie a string or fishing
line (not included) to the outside magnet and drop
in the aquarium while holding the line. The
magnets should reconnect when close. Reattach
following Step 2.
Maintenance
With regular use, the pads on the
magnetic cleaner will become worn
down and will not clean effectively.
Aq_ProMag_instructions-A5.indd 1
™
Replace the pads every 3 months with
Aqueon ProMag replacement cleaning
pads, which are available from your
favorite pet supply retailer.
Instructions
Please read these
instructions before
attempting to use
this product.
Aqueon
®
A product of Central Aquatics
(Division of Central Garden & Pet)
Franklin, WI 53132 888.255.4527
Aqueon
®
and It's all about the fish
®
are
registered trademarks of Central Garden & Pet
© 2010 Central Garden & Pet
4/22/10 9:15 AM
Need help?
Do you have a question about the ProMag and is the answer not in the manual?
Questions and answers
glass cleaner will not clip on.seams to tight
The Aqueon ProMag glass cleaner may not clip on or hold firmly if the glass wall is too thick for the size of the magnet. In that case, a larger sized scraper may be necessary. Tight seams are not mentioned as a reason.
This answer is automatically generated
glass cleaner seams to tight wont clip on