Step 1; Step 2 - modway EEI-2263 Quick Manual

EEI-2263
ARMLESS CHAIR

STEP 1:

Remove the plastic covers which pre-install in the end of the Seat Frame ( ) by using Allen Wrench (C).
Leg ( ) on a carpeted or padded area as shown.
Please put
Insert Top Rail (1) and Seat Frame (4) into the
Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of the
Right Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Left Leg (2).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.

STEP 2:

Carefully place the assembled chair at your desired position.
Put the Seat Cushion (5) and Back Cushion (6) to assembled chair frame as shown.
Customer Service 609-256-9000︱www.modway.com
.
Assembly is completed. The chair is ready to enjoy now!
as shown.
6
5
Page 2 of 2