Connect The Cables, Fpg 411 - Xylem FLYGT Concertor FPG 411 Installation, Operation And Maintenance Manual

4 Electrical Installation
CAUTION: Electrical Hazard
Prevent cables from becoming sharply bent or damaged.
Requirements
These requirements apply for electrical installation:
• All fuses and circuit breakers must have the proper rating, and comply with
local regulations.
• The cables must be in accordance with the local rules and regulations.
Cables
These requirements apply for cable installation:
• The cables must be in good condition, not have any sharp bends, and not be
pinched.
• The sheathing must not be damaged and must not have indentations or be
embossed (with markings, etc.) at the cable entry.
• The minimum bending radius must not be below the accepted value.
• Use cables with appropriate temperature rating.

4.1 Connect the cables, FPG 411

For more information about the connection terminals, see
24.
2
1
1. Connect T3 and T4 from the pump.
2. Connect the DeviceNet cable between the gateway and the HMI.
Description
Ground
CAN low
Shield
14
7
HMI terminal
GND
L
—
FPG 411, FPG 412 Installation, Operation, and Maintenance Manual
3
4
5
6
Cable color
Black
Blue
Transparent
Terminals on page
1. Analog output
2. Digital inputs
3. + 24 VDC
4. Modbus slave
5. HMI
6. Digital outputs
7. T3, T4
FPG terminal
1
2
3