Advertisement
Product Description
Interactive Digital Signage Computer Module Gen 2 is designed to slide into the bay on the rear
of the Interactive Digital Signage Gen 2 touchmonitors, without any effect on the monitor's
form factor or requiring any extra cabling, turning your Interactive Digital Signage TouchMonitor
into an Interactive Digital Signage All-In-One TouchComputer.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user's manual to
maximize the life of your unit and prevent risks to user safety.
This manual contains information that is important for the proper setup and maintenance of the
Computer Module. Before setting up and powering on your new computer module, read through
this manual, especially the Installation chapter.
Chapter 1 - Introduction
User Guidel–Computer Module
SW602000
Rev
A, Page 4 of 20
Advertisement
