I/O Board; Removing The I/O Board - Dell Inspiron 16 7610 Service Manual

CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
4. Replace the three screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x5) that secure the right-display hinge to the palm-rest and keyboard assembly.
7. Connect the display cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in

I/O board

Removing the I/O board

Prerequisites
1. Follow the procedure in
2. Enter Service Mode.
3. Remove the base cover.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
34 Removing and installing components
After working inside your
Before working inside your
computer.
computer.